There are a whole range of Lexmark and IBM printer error codes. If it is difficult to diagnose which is which, then here's a primer to help you find!
Error code 22: No paper
This could be a paper jam or a shortage of paper in your IBM and Lexmark printers. Make sure you have enough paper in the tray and also check if there are sediments collected along the journey of paper. Check if the sensor flag for input is broken or notand ensure the system boards and cable-2 is not defective.
Error code 31: Paper change needed
This means that the Lexmark and IBM printers consists of different configuration that is required in the software. Be sure to change the paper to adjust the size. Also check the setting of the printer software for all the problems and the system board for any fault.
Error codes 41 and 43: related characters
This error code usually indicates that the particular characteris needed, not in the Lexmark and IBM. This could indicate a defective card or a character fault on the system. It could also mean that the font card is removed when the device was turned on. If the font card is defective sure to get a new one.
Error code 54: error number
This error code indicates that the settings are different for the series configuration between your computer and printer. Make sure the communication cable, I / O cable and the systemThe cards are not damaged or improperly connected.
Error code 89: Overloaded output tray
This error code means that the tray is full. Be sure to remove paper from the tray. You need to check the operation of their respective flags. You can also try to replace the photo sensor for the card.
Error code 9920: the temperature of the fuser
For this error code that is necessary to measure the resistance on the fuser and the thermal fuse, lamp monitorand the thermistor. It could also be a problem of low voltage. Check to see if there is continuity of the system and the cable 1 in the power cord to the fuser.
Error code 970: Wrong Turn the fan
This means that the fan inside the Lexmark and IBM is not turned on. You could try the cable, which are newly established between the motherboard and the fan. Also try to reset the printer.
Error code 24: Incorrect manual feed
This error code maybe due to a number of reasons. If you try to put paper inside manual feed at the same time lift the paper from the printer then the error could occur. Make sure you put, not on paper in the manual feed slot until and unless they are specifically requested.
No comments:
Post a Comment